![]() ![]() I like having this as ballast, rather than the RHINO rear blade - it is less apt to dig into the ground as I'm digging with the FEL. Pressure washing got rid of most of the white on the plastic trash can. Since I took this picture I have trimmed off some of the excess steel. I ran out of redimix, and tossed in an additional 2 bags of mortar - I think they were about 50 lbs each. The trash can reshaped itseld a bit rounder. Then I mixed 6 80 lb bags of redimix concrete, and poured it in. Capacity is 4.75 cubic feet plenty of room for adequate ballasting materials. Its overall height to the top link connection is 29 inches. Plans to make a Hydraulic Log Grapple for Cat 0 or 1 3pt Hitch, Tractor Mounted. This box measures 24 inches wide, 20 inches high, and 16.5 inches deep. Small but Powerful DIY Log Splitter Diecast Masters (85922) 1/50 Scale. That arm is the ugly iron piece for my 3rd point hitch attachment! Our ballast box fits category I 3-point hitches, and is 3-point quick hitch compatible. ![]() At one time I had built a third arm for my back hoe, but its bucket was once on the ground when I took off, and twisted up the cylendar to it, so I removed the arm and restored the backhoe to normal. I had half a dozen 5' pieces of re-bar that I put through the holes in the drawbar, the bent them around inside the bin. I cut it, and poked a drawbar through it, close to one end. I used an either 22 or 27 gallon more or less rectangular plastic trash can - I think it was 22 gal.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |